Scrap Shears ALIGATOR L400

ALIGATOR Scrap Shears L400 are used for materials up to 100 mm thick

Data Sheet


Their pressure strength is 250tons, blade length 1500m, max. spread 750mm


Shears Clamp

Holding Clamp


4000 kN


Cylinder Diameter

280 mm

160 mm

Piston Diameter

180 mm

105 mm

Steering System

Electro-hydraulic switch valve, control panel

Nominal Pressure

20 MPa

Engine Power

2x18,5 kW

Pump maximum displacement

2x160 cm3

Hoist Frequency

8-10 times per minute

Blade Length

1500 mm

Max. Blade Spread

750 mm

Max. Size of Cut Material

Angle plate

180x180x15 mm (3 pieces)


320x132x11,5 mm


320x90x10 mm


20x1000/30x800 mm

Square rod

100x100 mm

Round rod

Φ 110 mm






3200x1200x2200 mm

Oil tank

2900x1500x1200 mm

Hydraulic ALLIGATOR scrap shears are powered with electricity. The electric engine drives a pump which compresses liquid in two hydraulic servomotors. One is responsible for the clamp of the shears, the other - for the holding clamp. Liquid between the servomotors is circulated through an electro-hydraulic switch valve, which ensures equal distribution of the strength of pressure and cut.

When the shears operate, the material placed on the lower shear of ALLIGATOR is first held by the holding clamp, and then cut by the main shears clamp. The cut is effective thanks to the weight of the shears clamp and special design of high quality steel blade. Blades are on the mobile and stationary shears clamp. Each blade has four working edges. When one edge is worn down, rotate the blade to use another one.

Hydraulic ALLIGATOR scrap shears allow to adjust the height of spread of the shears. If you cut large quantities, you can lower both clamps to shorten the time between cuts and allow for fast and effective work. The clamps can be raised to cut larger materials.

The shears come also equipped with an automatic speed switch, which adjusts the strength and speed of the shears to the thickness and resistance of the material being cut, which saves a lot of electric energy.

Hydraulic ALLIGATOR scrap shears are controlled with a very convenient control panel - you can start or stop the work at any time.

Watch movies



Download Data Sheet - Scrap Shears ALLIGATOR L400

Contact details

MACHTEK sp. z o.o. - recycling machines

Łekno 23
76-037 Będzino, POLAND

tel: + 48518 374 309



pl logo bottom

We are a trading company.
We sell recycling equipment and machines.

Machines which proved their worth in practice,
with the best cost-to-benefit ratio.