Scrap Shears ALLIGATOR L200

ALLIGATOR Scrap Shears L200 are used for materials up to 70mm thick

Data Sheet


Their pressure strength is 200tons, blade length 800mm, max. spread 380mm


Shears Clamp

Holding Clamp


2000 kN

300 kN

Cylinder Diameter

200 mm

125 mm

Piston Diameter

140 mm

80 mm

Steering System

Electro-hydraulic switch valve, control panel

Nominal Pressure

20 MPa

Engine Power

22 kW

Pump maximum displacement

160 cm3

Hoist Frequency

8-10 times per minute

Blade Length

800 mm

Max. Blade Spread

380 mm

Max. Size of Cut Material

Angle plate

140x140x10 mm (3 pieces)


250x118x10 mm


280x82x7,5 mm


30x400 mm

Square rod

70x70 mm

Round rod

Φ 75 mm






2500x900x1500 mm

Oil tank

1400x1000x1300 mm

Hydraulic ALLIGATOR scrap shears are powered with electricity. The electric engine drives a pump which compresses liquid in two hydraulic servomotors. One is responsible for the clamp of the shears, the other - for the holding clamp. Liquid between the servomotors is circulated through an electro-hydraulic switch valve, which ensures equal distribution of the strength of pressure and cut.

When the shears operate, the material placed on the lower shear of ALLIGATOR is first held by the holding clamp, and then cut by the main shears clamp. The cut is effective thanks to the weight of the shears clamp and special design of high quality steel blade. Blades are on the mobile and stationary shears clamp. Each blade has four working edges. When one edge is worn down, rotate the blade to use another one.

Hydraulic ALLIGATOR scrap shears allow to adjust the height of spread of the shears. If you cut large quantities, you can lower both clamps to shorten the time between cuts and allow for fast and effective work. The clamps can be raised to cut larger materials.

The shears come also equipped with an automatic speed switch, which adjusts the strength and speed of the shears to the thickness and resistance of the material being cut, which saves a lot of electric energy.

Hydraulic ALLIGATOR scrap shears are controlled with a very convenient control panel - you can start or stop the work at any time.

Watch movies



Download Data Sheet - Scrap Shears ALLIGATOR L200

Contact details

MACHTEK sp. z o.o. - recycling machines

Łekno 23
76-037 Będzino, POLAND

tel: + 48518 374 309



pl logo bottom

We are a trading company.
We sell recycling equipment and machines.

Machines which proved their worth in practice,
with the best cost-to-benefit ratio.